Ultra Boss Model D225

The D-225 Ultra BOSS is the “Ultimate” in our line of Aqua Miser™ high-pressure blaster/cleaner system. The D-225 is computer controlled via transducers and a full color touch screen, self-sufficient, diesel powered high-pressure blasting/cleaning system used as a water only unit or combined with our patented low volume abrasive media injection system. This is a standard feature on all D-225 units. With this combination of blasting technologies there isn’t much this unit can’t do. All that is required is a clean adequate water supply source of 15-20gpm or greater. The D-225 is a sturdy framed mobile blast system intergraded with tandem axles and a tongue so as to function as a trailer unit. The D-225 is also available in a skid mount version. Either unit is capable of being lifted by crane in or on to any job site via a sturdy center lifting bale, also standard on all D-225 units. The D-225 is capable of pressures up to 40,000psi@6.2gpm in the mono gun mode and 3.1gpm in the dual gun mode. The dual gun mode is achieved by the use of (2) tumble boxes. Each tumble box is sized to match the gun pressure. This means that there is considerably less water to contain and dispose of. The lower than most gpm directly relates to less operator fatigue due to reduced gun thrust. Also, less water is required to complete the job (only a ¾” garden hose is needed for feed water). The Aqua Miser™ D-225 Ultra BOSS abrasive injection system is different than any other system out today. This pressure fed system feeds virtually any abrasive media up to distances exceeding 500 ft away or up to 200 ft straight up. The abrasives are used to attain a wide variety of blasting specifications, including concrete preparation, profiling steel, white metal finish, degreasing and cleaning to name a few. The D-225 can use traditional standard abrasives for high strip rates, as well as water soluble abrasives for environmentally sensitive work. Using our micro media flow control system you can adapt to complete delicate blasting needs and requirements. Other features include a robust 38cfm rotary screw air compressor. This means there’s no need for an external air source. The D-225 is triggered electrically by the operator. This triggering system uses micro voltage technology via an intrinsic barrier to prevent any shock hazards to the operator or create a spark while working in flammable areas. All controls of the D-225 are electric over pneumatic so all actions of the unit are controlled electrically but air actuated. When the trigger is engaged the unit will engage the PTO and the engine throttle. Engine RPM will increase until the HP pump pressure reaches the HP set point called out and set on the full color touch control screen. When the trigger is disengaged the unit returns to an idle state and makes no pressure. This on and off control system translates into less fuel use, less wear and tear on the system, and eliminates the need for expensive un-loaders, dump valves and tumble boxes.